Biddle IndAC Specifikace

Industrial Air CurtainModel IndACVersion 1.5 19-01-2007EnglishManual Q

B 10 Manual model IndAC 2.4.4 Adjusting and securing 1 Position the units against one another, in one line, by placing the suspension rails 6

Industrial Air Curtain 2 Installation Version 1.5, English (19-01-2007) 11 With installation position type 1: In doing so, allow for a clearance of 1

B 12 Manual model IndAC c Caution: Screw the coupling plates to both sides of the unit. 5 Position the third unit, if any, in the same way. 2.5

Industrial Air Curtain 2 Installation Version 1.5, English (19-01-2007) 13 2.7 Connecting the fans 2.7.1 General The fans in the units are powered ce

B 14 Manual model IndAC - Apply a cable gland in the feed-through 5 for pull relief purposes. 4 Connect the feeder cable to the terminal block

Industrial Air Curtain 2 Installation Version 1.5, English (19-01-2007) 15 - Lay the cable in the cable compartment 4. w Warning: Do not allow the c

B 16 Manual model IndAC 2.10 Switching on and checking operation For all units: 1 Check the following connections: - power supply; - cabling

Industrial Air Curtain 3 Maintenance Version 1.5, English (19-01-2007) 17 3 Maintenance 3.1 Safety instructions w Warning: Maintenance works may be p

B 18 Manual model IndAC 3.2.2 Heating element For water-heated units: 1 Remove inlet grille 1. For units with electric heating: 1 Set the i

Industrial Air Curtain 3 Maintenance Version 1.5, English (19-01-2007) 19 3.4.2 Annual maintenance - Perform all monthly checks. - Check the cablin

B 2 Manual model IndAC Copyright All the information and drawings in this manual are the property of Biddle and may not be used (other than for

B 20 Manual model IndAC 4 Solving problems 4.1.1 General If the air curtain does not work, or not properly, perform the checks mentioned below.

Industrial Air Curtain Blank Version 1.5, English (19-01-2007) 21

B Blank 22 Manual model IndAC

Industrial Air Curtain Blank Version 1.5, English (19-01-2007) 23

Declaration of Conformity CE declaration IndAC standard.doc Manufacturer: Biddle BV, Address: Markowei 4 9288 HA Kootstertille THE NETHERLAN

Industrial Air Curtain Contents Version 1.5, English (19-01-2007) 3 Contents 1 Introduction ...4 1.1 About this manual ...

B 4 Manual model IndAC 1 Introduction 1.1 About this manual This manual describes the installation and maintenance of the Industrial Air Curtai

Industrial Air Curtain 1 Introduction Version 1.5, English (19-01-2007) 5 1.3 About the unit 1.3.1 Applications The air curtain model IndAC is design

B 6 Manual model IndAC 0 horizontal, above door 1L vertical, left of door, square to wall 1R vertical, right of door, square to wall 2L vertica

Industrial Air Curtain 1 Introduction Version 1.5, English (19-01-2007) 7 n Note : On delivery, some parts may have been packaged within the unit (be

B 8 Manual model IndAC 2 Installation 2.1 Safety instructions w Warning: Installation works may be performed by qualified technical staff only.

Industrial Air Curtain 2 Installation Version 1.5, English (19-01-2007) 9 Example of an auxiliary structure You may also fix the units directly to t